Dell POWEREDGE M1000E User Manual
Page 1027
39-27
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
OL-13270-03
Chapter 39 Configuring IPv6 Unicast Routing
Displaying IPv6
shows the privileged EXEC commands for monitoring IPv6 on the switch.
shows the privileged EXEC command for displaying EIGRP IPv6 information.
shows the privileged EXEC commands for showing IPv4 and IPv6 address types on the
switch.
Table 39-2
Commands for Monitoring IPv6
Command
Purpose
show ipv6 access-list
Display a summary of access lists.
show ipv6 cef
1
1.
This command is not supported on the Catalyst Switch Module 3012.
Display Cisco Express Forwarding for IPv6.
show ipv6 interface interface-id
Display IPv6 interface status and configuration.
show ipv6 mtu
Display IPv6 MTU per destination cache.
show ipv6 neighbors
Display IPv6 neighbor cache entries.
show ipv6 ospf
Display IPv6 OSPF information.
show ipv6 prefix-list
Display a list of IPv6 prefix lists.
show ipv6 protocols
Display IPv6 routing protocols on the switch.
show ipv6 rip
Display IPv6 RIP routing protocol status.
show ipv6 route
Display the IPv6 route table entries.
show ipv6 routers
Display the local IPv6 routers.
show ipv6 static
Display IPv6 static routes.
show ipv6 traffic
Display IPv6 traffic statistics.
Table 39-3
Commands for Displaying EIGRP IPv6 Information
Command
Purpose
show ipv6 eigrp [as-number] interface
Displays information about interfaces configured for EIGRP IPv6.
show ipv6 eigrp [as-number] neighbor
Displays the neighbors discovered by EIGRP IPv6.
show ipv6 eigrp [as-number] traffic
Displays the number of EIGRP IPv6 packets sent and received.
show ipv6 eigrp topology [as-number | ipv6-address]
[active | all-links | detail-links | pending | summary |
zero-successors]
Displays EIGRP entries in the IPv6 topology table.
Table 39-4
Commands for Displaying IPv4 and IPv6 Address Types
Command
Purpose
show ip http server history
Display the previous 20 connections to the HTTP server, including the IP
address accessed and the time when the connection was closed.
show ip http server connection
Display the current connections to the HTTP server, including the local and
remote IP addresses being accessed.