Dell POWEREDGE M1000E - Manual (Page 1119)

44-41
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
OL-13270-03
Chapter 44 Configuring IP Multicast Routing
Configuring Optional IGMP Features
To disable groups on an interface, use the no ip igmp access-group interface configuration command.
This example shows how to configure hosts attached to a port as able to join only group 255.2.2.2:
Switch(config)# access-list 1 255.2.2.2 0.0.0.0
Switch(config-if)# interface gigabitethernet1/0/1
Switch(config-if)# ip igmp access-group 1
Changing the IGMP Version
By default, the switch uses IGMP Version 2, which provides features such as the IGMP query timeout
and the maximum query response time.
All systems on the subnet must support the same version. The switch does not automatically detect
Version 1 systems and switch to Version 1. You can mix Version 1 and Version 2 hosts on the subnet
because Version 2 routers or switches always work correctly with IGMPv1 hosts.
Configure the switch for Version 1 if your hosts do not support Version 2.
Beginning in privileged EXEC mode, follow these steps to change the IGMP version. This procedure is
optional.
To return to the default setting, use the no ip igmp version interface configuration command.
Modifying the IGMP Host-Query Message Interval
The switch periodically sends IGMP host-query messages to discover which multicast groups are present
on attached networks. These messages are sent to the all-hosts multicast group (224.0.0.1) with a
time-to-live (TTL) of 1. The switch sends host-query messages to refresh its knowledge of memberships
present on the network. If, after some number of queries, the software discovers that no local hosts are
members of a multicast group, the software stops forwarding multicast packets to the local network from
remote origins for that group and sends a prune message upstream toward the source.
Step 7 show ip igmp interface [interface-id] Verify your entries.
Step 8 copy running-config startup-config (Optional) Save your entries in the configuration file.
Command Purpose
Command Purpose
Step 1 configure terminal Enter global configuration mode.
Step 2 interface interface-id Specify the interface to be configured, and enter interface
configuration mode.
Step 3 ip igmp version {1 | 2} Specify the IGMP version that the switch uses.
Note If you change to Version 1, you cannot configure the ip igmp
query-interval or the ip igmp query-max-response-time
interface configuration commands.
Step 4 end Return to privileged EXEC mode.
Step 5 show ip igmp interface [interface-id] Verify your entries.
Step 6 copy running-config startup-config (Optional) Save your entries in the configuration file.