Dell POWEREDGE M1000E - Manual (Page 962)

38-70
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
OL-13270-03
Chapter 38 Configuring IP Unicast Routing
Configuring ISO CLNS Routing
To disable IS-IS routing, use the no router isis area-tag router configuration command.
This example shows how to configure three routers to run conventional IS-IS as an IP routing protocol.
In conventional IS-IS, all routers act as Level 1 and Level 2 routers (by default).
Router A
Switch(config)# clns routing
Switch(config)# router isis
Switch(config-router)# net 49.0001.0000.0000.000a.00
Switch(config-router)# exit
Switch(config)# interface gigabitethernet1/0/1
Switch(config-if)# ip router isis
Switch(config-if)# clns router isis
Switch(config)# interface gigabitethernet1/0/2
Switch(config-if)# ip router isis
Switch(config-if)# clns router isis
Switch(config-router)# exit
Router B
Switch(config)# clns routing
Switch(config)# router isis
Switch(config-router)# net 49.0001.0000.0000.000b.00
Switch(config-router)# exit
Switch(config)# interface gigabitethernet1/0/1
Switch(config-if)# ip router isis
Switch(config-if)# clns router isis
Switch(config)# interface gigabitethernet1/0/2
Switch(config-if)# ip router isis
Switch(config-if)# clns router isis
Switch(config-router)# exit
Router C
Switch(config)# clns routing
Switch(config)# router isis
Switch(config-router)# net 49.0001.0000.0000.000c.00
Switch(config-router)# exit
Switch(config)# interface gigabitethernet1/0/1
Switch(config-if)# ip router isis
Switch(config-if)# clns router isis
Switch(config)# interface gigabitethernet1/0/2
Switch(config-if)# ip router isis
Switch(config-if)# clns router isis
Switch(config-router)# exit
Configuring IS-IS Global Parameters
These are some optional IS-IS global parameters that you can configure:
• You can force a default route into an IS-IS routing domain by configuring a default route controlled
by a route map. You can also specify other filtering options configurable under a route map.
• You can configure the router to ignore IS-IS LSPs that are received with internal checksum errors
or to purge corrupted LSPs, which causes the initiator of the LSP to regenerate it.
• You can assign passwords to areas and domains.
• You can create aggregate addresses that are represented in the routing table by a summary address
(route-summarization). Routes learned from other routing protocols can also be summarized. The
metric used to advertise the summary is the smallest metric of all the specific routes.
• You can set an overload bit.