Dell POWEREDGE M1000E - Manual (Page 105)

3-21
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
OL-13270-03
Chapter 3 Assigning the Switch IP Address and Default Gateway
Scheduling a Reload of the Software Image
When the switch is connected to a PC through the internal Ethernet management port, you can download
or upload a configuration file to the boot loader by using TFTP. Make sure the environment variables in
Table 3-5 are configured.
Scheduling a Reload of the Software Image
You can schedule a reload of the software image to occur on the switch at a later time (for example, late
at night or during the weekend when the switch is used less), or you can synchronize a reload
network-wide (for example, to perform a software upgrade on all switches in the network).
Note A scheduled reload must take place within approximately 24 days.
SWITCH_NUMBER set SWITCH_NUMBER
stack-member-number
Changes the member number of a stack
member.
switch current-stack-member-number renumber
new-stack-member-number
Changes the member number of a stack member.
Note This command is supported only on
stacking-capable switches.
SWITCH_PRIORITY set SWITCH_PRIORITY
stack-member-number
Changes the priority value of a stack member.
switch stack-member-number priority
priority-number
Changes the priority value of a stack member
Note This command is supported only on
stacking-capable switches.
Table 3-4 Environment Variables (continued)
Variable Boot Loader Command Cisco IOS Global Configuration Command
Table 3-5 Environment Variables for TFTP
Variable Description
MAC_ADDR Specifies the MAC address of the switch.
Note We recommend that you do not modify this variable.
However, if you modify this variable after the boot loader is up or the value
is different than the saved value, enter this command before using TFTP.
IP_ADDR Specifies the IP address and the subnet mask for the associated IP subnet of
the switch.
DEFAULT_ROUTER Specifies the IP address and subnet mask of the default gateway.