5 port based vlan control, Port based vlan control – CANOGA PERKINS 9145E NID Software Version 4.10 User Manual
Page 160
9145E NID Software User’s Manual
Port Information
Port Configuration
148
5.2.5 Port Based VLAN Control
The Port Based VLAN Control screen (Figure 5-16) is used to specify which VLANs, if any, are
allowed to pass through each port. The 9145E can be configured to support up to 4094 VLANs.
NOTE:If a User or Network port is configured to use S-Tags with the Tunnel Management
feature, this screen applies only to S-Tag VLANs.
From the Port Configuration screen, select Port Based VLAN Control (5) and press Enter. The
Port Based VLAN Control screen (Figure 5-16) opens. The default setting is All VLANs Allowed.
To specify which VLANs will be included or excluded, use the Add, Add Range, Delete, and
Delete Range controls at the bottom of the screen. Press Esc to return to the Port Based VLAN
Control screen.
Figure 5-16 Port Based VLAN Control screen
1. PBVC Mode Determines which ports are enabled. Press the Space bar to select User
Port Enabled Only, Net Port Enabled Only, Both Ports Enabled, or Disabled. A setting of
Disabled allows all VLANs to pass through both ports.
2. Add Adds one VLAN ID at a time to the screen list. Enter a VLAN ID value between 2
and 4094 and press Enter.
3. Add Range Adds a range of VLAN IDs to the screen list. Type the group of VLAN IDs
you want to add and press Enter. The value must be between 2 and 4094.
4. Delete Removes one VLAN ID at a time from the screen list. Type the VLAN ID you want
to remove and press Enter. The value must be between 2 and 4094.
Canoga Perkins Corp. Ethernet Network Interface Device 29-JAN-2009
9145E-101-1-0 V04.10 10:22:35
--------------------------PORT BASED VLAN CONTROL-------------------------------
65 of 100 VLAN IDs
Port Based VLAN Control List:
2 14 24 38 52 64 76
3 15 27 39 53 65 77
4 16 28 40 54 66 90
7 17 29 41 55 69 91
8 18 30 42 56 70 92
9 19 31 43 59 71
10 20 32 44 60 72
11 21 33 49 61 73
12 22 34 50 62 74
13 23 37 51 63 75
PBVC Mode: User Port Enabled Only
Select [(1) PBVC Mode, (2) Add, (3) Add Range, (4) Delete, (5) Delete Range,
(F)irst, (P)rev, (N)ext, (L)ast]:
------------------------------------Messages-----------------------------------