CANOGA PERKINS 9145E NID Software Version 4.10 - Manual (Page 268)

9145E NID Software User’s Manual Configuring EVC
EVC Configuration
256
12.2.3 Modify an EVC record
1. On the EVC Record List screen (Figure 12-3), type E and press Enter. The current record
is highlighted.
2. Press the Space bar to scroll through the list and highlight the record to modify. When the
record you want to modify is highlighted, press Enter. The Modify EVC Configuration
Record screen (Figure 12-5) opens.
Figure 12-5 Modify EVC Configuration screen
3. To change the Administrative State, type 1 and press Enter. Press the Space bar to select
Up or Down, and press Enter.
4. To change the statistics display, type 2 and press Enter. Press the Space bar to select S-
VLAN, C-VLAN, or Disabled, and press Enter.
If you set the statistics mode for a service multiplexing record to C-VLAN then you can
see the service multiplexing statistics detailed at C-VLAN level (as in Figure 12-14).
To change the S-Tag PCP Value, type 3 and press Enter. Press the Space bar to select
Map from CVID, Static or Copy from Ingress, and press Enter.
5. To change the Static/Default PCP value for the S-Tag, type 4 and press Enter.
6. To change the T-Tag PCP value, type 5 and press Enter. Press the Space bar to select
Map from CVID, Static or Copy from Ingress, and press Enter.
7. To change the Static/Default PCP value for the T-Tag, type 6 and press Enter.
8. To change the CoS classification mode, type 7 and press Enter. Press the Space bar to
make a selection.
9. To modify CoS to Queue mapping, type 8 and press Enter. For steps, see “Mapping a
Queue on the User Port in C-VID” on page 261.
Canoga Perkins Corp. Ethernet 1G/10G Network Interface Device 29-AUG-2011
9145E-101-3-0 V04.10 14:09:42
-----------------------MODIFY EVC CONFIGURATION RECORD--------------------------
EVC ID: 1 STag: Enabled (88A8) TTag: Disable 0 (8100)
User Interface: USR
Network Interface: NET
Name: Test
Multiplexing type: Service Mux
Operational state: DOWN
1) Administrative state: UP
2) Statistics: Disabled
3) S-Tag PCP Value: Copy from ingress 4) Static/Default PCP Value: 0
5) T-Tag PCP Value: Copy from ingress 6) Static/Default PCP Value: 0
7) Assign Policer Profile
8) C-VLAN Translation
9) P-Bit Translation Table 10) P-bit translation Enabled/Disabled
11) View/modify C-VLAN List
(# of VLANs: 0)
Select [1-11] for attributes:
------------------------------------Messages-----------------------------------