CANOGA PERKINS 9145E NID Software Version 4.10 - Manual (Page 50)

9145E NID Software User’s Manual System Configuration
SYSLOG Client Configuration
38
3.9 SYSLOG Client Configuration
Use the SYSLOG Client Configuration screen to configure the 9145E to send log messages to a
SYSLOG Server. From the System Configuration screen, select SYSLOG Client Configuration
(8) and press Enter. The SYSLOG Client Configuration screen (Figure 3-23) opens.
On the SYSLOG Client Configuration screen, type the number of the SYSLOG setting to change
and press Enter. When entries are completed, press Esc to return to the System Configuration
screen.
Syslog Server IP Address Configure the IP address of the Syslog server. Two Syslog servers
can be configured.
Syslog Server Port Configure the Syslog Server port. The standard syslog port is 514. The port
setting should match with the Syslog server UDP port setting (1 - 65535).
Syslog Server Mask Define the level of severity of the messages to be send. There are eight
(8) levels of severity as defined in RFC 3164. The severity levels from highest to lowest are:
• Emergency System is unusable.
• Alert Action must be taken immediately.
• Critical Critical Condition.
• Error Error Condition.
• Warning Warning Condition.
• Notice Normal but significant condition.
• Informational Informational messages
• Debug Debug level messages. If you specify Debug, then all messages are sent about
the 9145E. If you specify Error, then all errors that are Emergency, Alert and Critical are
sent.
Figure 3-23 SYSLOG Client Configuration screen
Canoga Perkins Corp. Ethernet Network Interface Device 29-JAN-2009
9145E-101-1-0 V04.10 15:52:50
-------------------------SYSLOG CLIENT CONFIGURATION---------------------------
1. Syslog Server IP Address : 000.000.000.000
Syslog Server Port : 514
Syslog Server Mask : Debug
2. Syslog Server IP Address : 000.000.000.000
Syslog Server Port : 514
Syslog Server Mask : Debug
Select [1-2]:
----------------------------------Messages-------------------------------------