CANOGA PERKINS 9145E NID Software Version 4.10 - Manual (Page 292)

9145E NID Software User’s Manual Bandwidth Profiling
User to Network Egress Shapers
280
13.7 User to Network Egress Shapers
The are four shapers in the system. The shapers cannot be deleted and created, but they can be
disabled or enabled. An unassigned shaper is always disabled (that is, a shaper without a
profile). Each queue, identified by a <user port, queue> pair, can be assigned (or unassigned) to
one shaper.
13.7.1 Viewing the Shapers List
1. On the Bandwidth Profile Enforcement screen (Figure 13-3), type 3 and press Enter. The
Egress Shapers List screen (Figure 13-10) opens. There are 19 shapers.
Figure 13-10 Egress Shapers List screen
13.7.2 Modifying a Shaper
1. On the Egress Shapers List screen (Figure 13-10), type the number of the shaper you
wish to modify and press Enter. The Egress Shaper Configuration screen (Figure 13-11)
opens.
2. To change the bandwidth profile, type 1 and press Enter Press the Space bar to select a
Shaper Profile or None, and press Enter.
3. To enable or disable the shaper, type 2 and press Enter. Press the Space bar to select
Enabled or Disabled, and press Enter.
4. To assign a queue to a shaper, type 3 and press Enter. A specific queue can be assigned
to one shaper only. Type 1-4 to toggle the queue.
5. Type the number of the queue from which the shaper will be deleted and press Enter.
6. After toggling queues, press Esc and then A to accept your changes, or press Esc again
to cancel.
7. Press Esc to return to the Egress Shapers List screen.
Canoga Perkins Corp. Ethernet 1G/10G Network Interface Device 29-AUG-2011
9145E-101-2-0 V04.10 06:45:25
------------------------------ EGRESS SHAPER LIST -------------Items 1 - 4 of 4-
Color Marking Method: DEI Yellow PCP Value: N/A
Shaper Bandwidth Profile Status Number of Queues
1 None Disabled 0
2 None Disabled 0
3 None Disabled 0
4 None Disabled 0
Select Shaper [1-4]:
------------------------------------Messages-----------------------------------