CANOGA PERKINS 9145E NID Software Version 4.10 - Manual (Page 29)

System Configuration 9145E NID Software User’s Manual
IP/SNMP Agent Configuration
17
8. Aux IP Rate Limiting Enables or disables Auxiliary IP Rate Limiting. The rate limiting
function is used to rate limit the traffic being received from the Aux IP. The Aux IP Rate
Limiting default setting is enabled. Rate limiting may be set to Disable when running a
test, however, the setting will return to Enabled after five minutes. An on screen timer
shows time remaining until automatic enabling. To extend Disable Time beyond five
minutes, disable Rate Limiting again before Timer expiration.
Table 3-1. IP Diagnostic Function Capabilities
3.2.3 Host Table
On the IP/SNMP Agent Configuration screen (Figure 3-4), type 3 and press Enter. The Host
Access Table screen (Figure 3-8) opens.
Use this screen to configure the 9145E to send and receive SNMP, FTP, and Telnet traffic to the
Managing Host IP address, and access from specific Telnet clients when Telnet security is
enabled. Use the Host Access Table to configure access by each host including access type and
privileges (SNMP, FTP, Telnet).
Figure 3-8 Host Access Table screen
Function Management IP Test IP Auxiliary IP
Ping √ √ √
Latency & Jitter √ √ √
Performance Maintenance (PM) √ √ N/A
Service Availability Monitoring (SAM) √ √ N/A
Canoga Perkins Corp. Ethernet Network Interface Device 29-JAN-2009
9145E-101-1-0 V04.10 11:47:51
--------------------------------HOST ACCESS TABLE------------------------------
Managing Host Telnet FTP SNMP SNMP V1/V2c Rd V1/V2c Wr V1/V2c
IP/Mask Bits Access Access Access Protocol Community Community Access
172.016.000.000/16 All All Write V1/V2c/V3 public private Superv
Select [(A)dd, (D)elete, (E)dit, (M)ore]:
[(T)Send Discovery Request Trap, (S)end Synchronization Request Trap]
------------------------------------Messages-----------------------------------