CANOGA PERKINS 9145E NID Software Version 4.10 - Manual (Page 227)

Service OAM 9145E NID Software User’s Manual
Maintenance Associations
215
11.4.3 Delete a Maintenance Association
When you delete a Maintenance Association, all MEPs/MIPs associated with it are also deleted.
1. On the Maintenance Association List screen (Figure 11-12), type D and press Enter. The
current Maintenance Association is highlighted.
2. Press the Space bar to scroll through the list and highlight the Maintenance Association
you want to delete.
3. Press Enter to delete the highlighted Maintenance Association. You are prompted to
confirm the deletion.
11.4.4 Modify a Maintenance Association
1. On the Maintenance Association List screen (Figure 11-12), type E and press Enter. The
current MA is highlighted.
2. Press the Space bar to scroll through the Maintenance Associations and highlight an MA
to modify.
3. When the item you want to modify is highlighted, press Enter. The Maintenance
Associations Attributes screen (Figure 11-14) opens.
4. To change the CCM interval, type 1 and press Enter. The CCM interval is the interval at
which CCMs are sent by a MEP. Select 1 sec, 10 sec, or 100 ms, and press Enter.
NOTE: No more than two MEPs at 100msec are supported. Typically, these MEPs are used at
MD level 0 to monitor the physical link.
5. To add a VLAN to the VLAN list of this MA, type 2 and press Enter. You are prompted to
type a new VLAN ID. Type the VLAN ID and press Enter. The VLAN appears in the list.
Up to four VLANs can be added for each MA.
NOTE: For S-Tag MAs, the VLAN value is taken automatically from the SOAM All-to-One
Bundling Tunnel configuration and cannot be changed.
6. To remove a VLAN from the list, type 3 and press Enter. You are prompted to type the
number of the VLAN to remove. Type the VLAN number and press Enter. Some
restrictions apply to modifying and deleting VLANs:
• The first VLAN is the primary VLAN and cannot be modified.
• To delete the primary VLAN, you must delete all VLANs in the list and create a
new list.
• If a VLAN list is shared by two or more MAs/MEGs, it cannot be modified from this
user interface.
7. You can view or modify the peer MEPs list. Type 4 and press Enter. The Maintenance
Associations Peer MEPs screen opens. Up to 128 peer MEPs can be configured for an
MA or a MEG. The maximum number of peer MEPs per system is 256.
a. To add a peer MEP, type 1 and press Enter. You are prompted for the MEP ID num-
ber. Type the number and press Enter.