WaveWare Adaptive AlphaNet - Manual (Page 31)

Step-by-step tutorial in setting up connection devices, sites, and groups
2 — Installing AlphaNET™ 3.0 software and setting up sites 31
5. N
ext, enter information on the Sign Info tab:
Table 8: R & D setup (2 of 4): Site Editor (Sign Info) window
Item Name Directions
A
Tone on
Receipt
• Select Single Beep, Three Beeps, or Custom Tone (create
your own tone) if you want the signs in the address list to
beep each time these signs receive a new message.
• Select Tune File if you want the signs in the address list to
play a short melody each time these signs receive a new
message. Only available on an AlphaPremiere™ 9000
sign.
B Address List
The addresses of all the signs in this particular site (in this
case, 01 and 02 for the R & D site):
C
Counter
File...
See “How to edit a counter file” on page 81.
D
Automode
File...
Choose an automode table, if desired. (Compatibility on the
Site Info tab must be Alpha 2.0 or Alpha 3.0 for Automode
Table… to be available.)
See “How to create and use a custom automode sequence”
on page 107 for more information.
E Tune File
Signs in the address list can play a tune file each time they
receive a message. To do this, select Tone on Receipt
>Tune File. Then browse and select one of the pre-
programmed tune files. Only available on an
AlphaPremiere™ 9000 sign.
F Duration In seconds, the length of time each beep will sound.
G Repeat
The number of times the beep (or series of beeps) will
sound.
H
Extended
Memory
Used for large file transmissions, such as when sending
graphics to a display sign. Must be selected when sending
to an AlphaPremiere™ 9000 or AlphaEclipse™ sign.
C
A
B
D
E
G
H
F
H I N T
A long sequence of sign
addresses can be entered using a
comma.
For example, the address list:
5,6,7,8,9 could also be entered
as 5–9.
Addresses of
R & D signs
(See NOTE at the end of
this example.)
R & D
R & D
01
02