AMETEK BPS Series Programming Manual - Manual (Page 123)

BPS / MX / RS Series SCPI Programming Manual AMETEK Programmable Power
Manual P/N 7003-961 Rev. AA 123
SYSTem:COMMunicate:SERial:BAUD
This command will set the SERial communication baud rate.
Command Syntax SYSTem:COMMunicate:SERial:BAUD <NRF>
Parameters 1200 | 2400 | 4800 | 9600 | 38400 | 57600* | 115200*
(* = available on MX Series II only.)
Example SYST:COMM:SER:BAUD 9600
Returned Parameters <NR1>
SYSTem:COMMunicate:SERial:PARity
This command will set the SERial communication parity.
Command Syntax SYSTem:COMMunicate:SERial:PARity <parity>
Parameters NONE | EVEN | ODD
Example SYST:COMM:SER:PAR NONE
Returned Parameters <CRD>
SYSTem:COMMunicate:SERial:BITS
This command will set the SERial communication number of data bits.
Command Syntax SYSTem:COMMunicate:SERial:BITS <NRF>
Parameters 7 | 8
Example SYST:COMM:SER:BITS 8
Returned Parameters <NR1>
SYSTem:COMMunicate:SERial:SBITs
This command will set the SERial communication number of stop bits.
Command Syntax SYSTem:COMMunicate:SERial:SBITs <NRF>
Parameters 1 | 2
Example SYST:COMM:SER:SBITs 1
Returned Parameters <NR1>