AMETEK BPS Series Programming Manual User Manual
Page 48
AMETEK Programmable Power
BPS / MX / RS Series SCPI Programming Manual
48
Manual P/N 7003-961 Rev AA
CALibrate[:SOURce]:VOLTage[:AC]:HRANge:ZERO <NRf+>
This command will set the calibration coefficent for the output voltage offset at the high
voltage range.
Command Syntax
CALibrate:VOLTage:HRANge:ZERO <NRf+>
Parameters
<NRf> (a value between -127 and +128)
Examples
CAL:VOLT:HRAN:ZERO +10
Query Syntax
CALibrate:VOLTage:HRANge:ZERO?
Returned Parameters
<NR1> (value range -127 to +128)
Related Commands
CAL:VOLT:HRAN CAL:VOLT:HRAN:HFR
CALibrate[:SOURce]:VOLTage[:AC]:HRANge:HFRequency <NRf+>
This command will set the calibration coefficent for the AC full scale output voltage at the
high voltage range and at high output frequency
Command Syntax
CALibrate:VOLTage:HRANge:HFRequency <NRf+>
Parameters
<NRf> (a value between -127 and +128)
Examples CAL:VOLT:HRAN:HFRequency
+10
Query Syntax
CALibrate:VOLTage:HRANge:HFRequency?
Returned Parameters
<NR1> (value range -127 to +128)
Related Commands
CAL:VOLT:HRAN:ZERO CAL:VOLT:HRAN
CALibrate[:SOURce]:VOLTage:HFRrequency
This query command retrieves the harmonic calibration coefficients for the IEC413 option.
Available only on MX/RS/BPS Series II models with firmware revision 4.20 or higher. This
query returns a comma-separated list of seven calibration coefficients. These coefficients
can only be set by performing a voltage measurement calibration.
Query Syntax
CALibrate:VOLTage:HFRequency?
Returned Parameters
<CRD>
Related Commands
CAL:IHAR?
CALibrate[:SOURce]:IHARmonic
This query command retrieves the interharmonic calibration coefficient for the IEC413
option. This query returns a comma-separated list of the calibration coefficient and the
frequency at which the calibration was peformed.
Query Syntax
CALibrate:IHARmonic?
Returned Parameters
<CRD>
Related Commands
CAL:VOLT:HFR