AMETEK BPS Series Programming Manual User Manual
Page 175
BPS / MX / RS Series SCPI Programming Manual
AMETEK Programmable Power
Manual P/N 7003-961 Rev. AA
175
IEC411:DIPS:ANGLe
This command sets the start phase angle for the dips.
Command Syntax
IEC411:DIPS:ANGLe
Parameters <numeric>
Examples IEC411:DIPS:ANGL
90
Query Syntax
IEC411:DIPS:ANGL?
Returned Parameters
<NR2>
IEC411:STATe
This command will enable the IEC411 option and initialize the associated data.
Command Syntax
IEC411:STATe <state>
Parameters <ON|OFF>
Examples IEC411:STAT
ON
Query Syntax
IEC411:STAT?
Returned Parameters
<boolean>
IEC411:VARiants:RUN[:ALL]
This command will cause the variants automated test sequence by the standard to run.
Refer to Table 14 in the User Manual.
Command Syntax
IEC411: VARiants:RUN[:ALL]
Parameters <none>
Examples IEC411:VAR:RUN
Query Syntax
none
Returned Parameters
<none>
IEC411: VARiants:RUN:SINGle
This command will run a single variant test once. The test is defined by the variants
parameters voltage, cycle and angle.
Command Syntax
IEC411:VARiants:RUN:SINGle
Parameters <none>
Examples IEC411:VAR:RUN:SING
Query Syntax
none
Returned Parameters
<none>