Guralp Systems CMG-6TD - Manual (Page 39)

CMG-6TD Installing the 6TD
configure.
The right-hand panel will change to show the current properties of the
device.
11. Switch to the Web Configuration tab, and click Go ( ) to open the
Web configuration interface.
Alternatively, click Use External Browser (
) to use your own Web
browser to configure the instrument.
12. Follow the steps in section 4.11.3 on page 39 to configure the module
from its Web interface.
4.11.2 Using DHCP
If you cannot install DeviceInstaller on your PC, or do not wish to, you can
also get access to the 6TD using a standard DHCP server. In most cases you
will need to have administrative privileges to do this.
1. Install and start the DHCP service on your PC.
2. Configure your wireless router or access point to use a network name
(SSID) of LTRX_IBSS
3. Disable any security features of the wireless router or access point.
4. Monitor the DHCP server to find out what IP address it gives to each
Wi-Port in range. If necessary, power cycle the sensor(s).
5. To configure a device, enter its IP address into a web browser.
4.11.3 Configuration with the Web interface
Once you have access to the Wi-Port's Web interface, you can configure it
with its proper settings.
1. The Web page is divided into three. A menu on the left switches
between pages of configuration options on the right. There is also a
banner at the top, which tells you the current firmware revision and
the MAC address.
MAN-T60-0002 39 Issue F - February 2014