Guralp Systems CMG-6TD - Manual (Page 99)

CMG-6TD Updating the 6TD
8 Updating the 6TD
The firmware of the 6TD can be updated remotely over its output port.
In Scream!’s main window, right-click on the instrument's icon and select
Terminal… from the pop-up menu. (If this fails, connect the instrument
directly to a serial port and right-click on the serial port instead.)
Check that there is two-way communication with the digitiser by pressing
Enter. The instrument should reply with ok on a new line.
Type ok­1 to enable advanced commands. The instrument will reply with a
message describing the current firmware version.
If the firmware needs updating:
1. Type load and press ENTER. The instrument will display
load C
The instrument will now wait up to ten seconds for you to provide a
firmware file.
2. Right-click on the terminal window and select Send file…:
Firmware updates for the 6TD normally have file-names like
uppern_319.hex.
3. Choose the required firmware image file and click .
MAN-T60-0002 99 Issue F - February 2014