Hypertherm Powermax30 XP Service Manual - Manual (Page 135)

Powermax30 XP Service Manual 808150 Revision 1 135
6 – Power Supply Component Replacement
4. Remove the connector at J12 by pressing up on the tab in the connection slot with a small blade screwdriver and
then pulling the connector out toward the power supply’s front panel.
Figure 69
5. Locate the studs that attach the white wire group and the red wire from the torch lead to the power supply’s center
panel (on the fan side of the power supply).
6. Use an 8 mm (5/16 inch) nut driver to remove the nuts from the studs, and slide the ring terminals off the studs.
Figure 70
Push tab toward connector
1
2
1 Red wire 2 White wire group