Hypertherm Powermax30 XP Service Manual - Manual (Page 52)

52 Powermax30 XP Service Manual 808150 Revision 1
4 – Operation
5. When the pierce is complete, drag the torch lightly along the workpiece to proceed with the cut.
Gouge a workpiece
You can use the Powermax30 XP with the general-purpose (standard) consumables for light gouging applications, such
as the removal of spot welds and tack welds.
 The system does not require a dedicated set of consumables or a special mode setting
for gouging. However, do not use the FineCut consumables for gouging applications.
1. Hold the torch so that the torch tip is slightly above the workpiece before firing the torch.
2. Hold the torch at a 45° angle to the workpiece with a small gap between the torch tip and the workpiece. Press the
trigger to obtain a pilot arc. Transfer the arc to the workpiece.