Hypertherm Powermax30 XP Service Manual - Manual (Page 165)

Powermax30 XP Service Manual 808150 Revision 1 165
6 – Power Supply Component Replacement
6. Place the wooden end of a swab, a stiff wire, or other similar item with a 0.23 cm (0.092 inch) diameter in each of the
five holes on the power board side of the base. Press each one in until the clips release and you can pull the base
and the attached magnetics away from the center panel.
Figure 96
7. Remove the six screws that hold the magnetics’ metal mounting plate in place. Remove the plate and the magnetics.
Figure 97
Holes