Hypertherm Powermax30 XP Service Manual - Manual (Page 172)

172 Powermax30 XP Service Manual 808150 Revision 1
7 – Torch Component Replacement
Disconnect the power, gas supply, and torch
1. Turn the plasma power supply switch to OFF (O).
2. Disconnect the power cord from the power source.
3. Disconnect the gas supply hose from the plasma power supply.
Figure 101
1
5
3
7
4
10
11
12
13
14
2
6
9
8
15
1 Right side of the handle
2 Cap-sensor switch
3 Start switch
4 Plunger screw
5 Plunger
6 Consumables
7 Torch body
8 Torch power wire
9 Left side of the handle
10 Screws (5)
11 Trigger assembly
12 Trigger spring
13 Gas hose fitting’s flange
14 Strain relief
15 Cap-sensor wire connector