Hypertherm Powermax30 XP Service Manual - Manual (Page 164)

164 Powermax30 XP Service Manual 808150 Revision 1
6 – Power Supply Component Replacement
4. Disconnect the air filter/regulator’s drain hose from the hole in the base of the power supply.
5. Use a 8 mm (5/16 inch) nut driver to remove the nut that attaches the ring connector for the output inductor’s white
wire to the stud labeled “WHT.”
Figure 95
2
3
1
1 Drain hose
2 Output inductor
3 White wire stud (“WHT”)