Hypertherm Powermax30 XP Service Manual - Manual (Page 143)

Powermax30 XP Service Manual 808150 Revision 1 143
6 – Power Supply Component Replacement
7. Unscrew the retainer nut that holds the air filter/regulator in the bracket on the center panel. See Figure 76.
8. Tip the bottom of the air filter/regulator and pressure switch assembly away from the power supply, and slide the
assembly out of the bracket. Gently tilt the top of the rear panel away from the power supply as you remove the
assembly, if needed.
Figure 76
2
3
1
1 Retainer nut
2 Center panel bracket
3 Air filter/regulator