Finecut consumables – Hypertherm Powermax30 XP Service Manual User Manual
Page 36
36
Powermax30 XP Service Manual 808150 Revision 1
3 – Torch Setup
FineCut consumables
Use the FineCut consumables for detailed cutting on thin gauge metal. The FineCut consumable set uses a FineCut
nozzle and a deflector with the same electrode, swirl ring, and retaining cap used in the general-purpose consumable set.
The FineCut nozzle must be installed only with the deflector, not the shield. Using the shield results in poor cut quality and
increased power demand because the torch-to-work distance is too great.
For guidelines on cutting with 120 V input, see
Recommendations for cutting at 120 V on page 49.
Figure 4 – FineCut consumable set
* Order the FineCut nozzle and electrode together using kit 428244. This kit contains 2 nozzles and 2 electrodes. Replace the nozzle
and electrode at the same time.
5
4
3
2
1
6
1
Torch
2
Electrode (420120)*
3
Swirl ring (420211)
4
Nozzle (420117)*
5
Retaining cap (420114)
6
Deflector (420115)