Nevion Multicon - Manual (Page 23)

Operation 23
ID: man-multicon Multicon Manual Rev. L
Figure 6.1 Web interface network settings
6.1.2 Change using Nevion Configurator
This section describes how to change the IP address of the Multicon controller using the Nevion
Configurator. The same procedure is applicable for changing IP configuration for control panels
and routers. The IP configuration procedure is described in detail below:
1. Open the Nevion Configurator.
2. Select a system to open or click cancel. Note that it is not necessary to open a system to
perform IP configuration.
3. Go to Tools -
> IP settings from the menu bar.
4. Select the appropriate filter from the drop down.
5. Current system only will only show devices in the currently open system.
6. All systems will show all devices detected by the Nevion Configurator grouped per sys-
tem.
7. Device types will show all devices grouped by device type.
Figure 6.2 Nevion Configurator device list
1. Select the device you want to modify the IP configuration for and enter correct IP config-
uration settings.
2. Click OK at the bottom of the window.
Note: The IP configuration for the Multicon controllers MUST be done
using the Nevion Configurator. It is NOT possible to modify IP address
settings by modifying files on the CF-card directly.