Nevion Multicon - Manual (Page 3)

7.1 General 29
7.2 Alarms Page 30
7.3 Log Page 31
7.4 Config Page 32
7.4.1 User and Access Setup 32
7.4.2 Date and Time 34
7.4.3 Flashlink 35
7.4.4 Debug Terminal 35
7.4.5 SNMP Setup 35
7.4.6 Maintenance 37
7.5 Manuals 37
8 Flashlink Web Interface 38
8.1 Flashlink Sub-system View 38
8.2 Flashlink Module View 38
8.2.1 Information Page 39
8.2.2 Configuration Page 40
8.2.2.1 Card Label 40
8.2.2.2 Advanced Configuration 41
8.2.2.3 Matrix Configuration 41
8.2.2.4 Alarm Configuration 42
8.2.2.5 Passive Modules 43
8.3 Multicon Module View 43
8.4 Flashlink Maintenance 44
8.4.1 Power Supply 44
8.4.2 Rack Labels 45
8.4.3 Stored System Configurations 45
8.4.3.1 Transfer System Configurations 46
8.5 Debug Terminal 46
8.6 Flashlink Firmware Upgrade 47
8.6.1 Transfer Firmware Files to Multicon 48
8.6.2 Micro Controller Upgrade Process 49
8.6.3 FPGA Upgrade Process 50
9 Web Control Interface 51
9.1 List View 51
9.2 Matrix View 53
9.3 Salvo View 54
10 System Overview 56
11 Software Upgrade 57
11.1 Introduction 57
11.1.1 GYDA-SC Upgrade 57
11.1.2 ETH-CON and SYSCON Upgrade 58