Nevion Multicon - Manual (Page 28)

Operation 28
ID: man-multicon Multicon Manual Rev. L
6.4 Firewall Configuration
In order for multiple Multicon controllers and the Nevion Configurator to work, a few select ports
must be open. These are described below.
Port 80 is required for communication between the Multicon Web interface and the Multicon con-
troller and must always be open.
Port 2836, 2837 and 2838 are required for communication between Multicon controllers that are
configured in the same system.
Port 3972 is required for communication between the Nevion Configurator and Multicon con-
trollers, control panels and routers in the system.
The Nevion Configurator uses broadcast to detect devices and requires that all devices in the sys-
tem are on the same IP sub-net.
Port 4381 is required for communication between Multicon controllers and control panels and
routers in the system.
Port Type Description
80 TCP HTTP traffic from UI to Multicon
(Web browser -
>
Multicon controller)
8080 TCP Web socket traffic from UI to Multicon
(Web browser -
>
Multicon controller)
2836 TCP + UDP Primary port for Spread distribution mechanism
(Multicon -
>
Multicon)
2837 TCP + UDP Aux port for Spread
(Multicon -
>
Multicon)
2838 TCP + UDP Aux port for Spread
(Multicon -
>
Multicon)
3972 TCP + UDP Nevion Configurator to device communication
(Nevion Configurator -
>
Multicon, Control Panel, Sublime routers)
4381 TCP MRP connections
(Control Panel -
>
Multicon)
(Multicon -
>
Sublime routers)
In addition, any ports used by third party protocol must be open.