RLE FMS V.1.13 - Manual (Page 101)

rletech.com FMS User Guide 101
3 Web Interface Configuration
3.4.24 Modbus/SNMP/BACnet/Telnet Master
This section provides configuration information for basic Master unit functionality. If you’d
like to configure more advanced features, refer to Chapter 4, “Advanced Communications -
Modbus, BACnet, and Telnet” on page 133 .
These pages allow users to configure Modbus, SNMP, BACnet, and Telnet features. While
most functionality is detailed here, some advanced communications and logging options are
described in greater detail in Chapter 4, “Advanced Communications - Modbus, BACnet, and
Telnet” on page 133 .
If you wish to configure the unit as a BACnet Master, BACnet communications must first be
configured. Refer to section “BACnet” on page 99 for more information.
If you’d like to use the FMS’s Telnet capabilities, refer to “Telnet/COM1 Configuration” on
page 158 .
Figure 3.39 Modbus/SNMP/BACnet/Telnet Master Configuration
Option Description
Modbus/TCP Slave
Enable
Use this option to enable the FMS as a Modbus Slave over
Ethernet TCP/IP.
Modbus/TCP Slave
Unit Identifier
Set the FMS Modbus/TCP Slave address (1-254). 0 = disabled.
Table 3.27 Modbus/SNMP/BACnet/Telnet Master Options