RLE FMS V.1.13 - Manual (Page 146)

146 FMS User Guide 970.484.6510
4 Advanced Communications - Modbus, BACnet, and Telnet
Alarm Type Designate which type of alarm this will be.
Alarm Thresholds:
High 2, High1, Low1,
Low2
Set high and low - or major and minor - thresholds for alarm analog
alarm values being read by these points.
Enumerated Active
Value
If you’d like to designate an enumerated active value, do so here.
Snmp Trap
Recipients
The SNMP/Syslog page allows you to configure SNMP trap
recipients. Once those are configured, you can designate which IP
addresses should receive traps for this register.
Map Box Size Customize the size of the mapped object. By default, the height of
the object, as it appears on the map, is approximately 20 pixels,
and the width automatically adjusts to the length of the text. This
setting allows users to expand the size of the object to fill a defined
area.
Map Coordinate Fine tune the location of the object on the map. Refer to “Map
(Facility Mapping)” on page 114 for further information.
Graphical Mapping Designate the device’s location on the FMS graphical map. Refer to
“Map (Facility Mapping)” on page 114 for further information.
Test Map View the mapped location of the point you’re currently configuring.
Option Description
Table 4.6 Individual Modbus Register Configuration Options