RLE FMS V.1.13 - Manual (Page 63)

rletech.com FMS User Guide 63
3 Web Interface Configuration
PDA Screen Width Sets the width of the PDA web pages in the FMS to match the PDA
device. The PDA web pages can be accessed from the Web
browser by entering /pda after the IP Address (e.g., 10.0.0.188/
pda). The FMS includes a PDA web page view for the Main Menu,
Identity and Alarm History pages only.
Analog Average Allows users to change the averaging method for analog inputs.
Normally, the system samples analog points once a second while
tracking high and low values for each analog point. After sixty
seconds, the high and low values for these points and the average
of these readings are recorded in the Minute Log.
To alter this method of averaging, change the value to one of the
values listed in the drop down menu. Zero or one maintains the
method described above; a higher value changes the method of
averaging, and the manner by which high and low values are
recorded. See Appendix B, “Analog Averaging” on page 187 .
HTML Main Page Determines the number of monitoring points displayed on the Main
Menu. With the default of “0,” the Summary Alarm Box, Internal
Temperature and Humidity Box and a link to View All Points are
displayed.
Settings greater than “0” will display the selected points with links to
the remaining points. Typically users display all installed points. If
the FMS is continuously monitored with a Web browser, it may be
desirable to set the HTML Main Page Points to “'0”' and monitor the
View all Points page.
Digital Status Active
Color
Determines the color of Digital Status points on the Main Menu
when the input is turned on. The options are green, gold and
magenta. Typically, points are configured to be green and turn red
on alarm. However, inputs configured for Digital Status do not
trigger notification. For these points, this setting determines the
color of the point when the input is on.
HTML Alarm History
Display
This option allows users to choose how alarms are acknowledged
in the Alarm History page. The FMS is defaulted to “And all
acknowledgments.” This means that at least two people must
acknowledge the alarm for the history to show it has been
acknowledged. If users want to allow only one person to
acknowledge the alarm to have the Alarm History page log it, select
the “Or the acknowledgments.”
Falcon Unit Map
Coordinate
You can add a link to this FMS home page to the FMS’s interactive
map. Use these fields to fine tune the coordinates of the FMS
Home Page link. Refer to Chapter 7, “Add a Link to the FMS Home
Page” on page 135 for further information.
Graphical Mapping If you’d rather drag and drop the FMS icon to adjust its location,
click the Graphical Mapping link.
Your FMS map will appear in the browser window. Drag and drop
the icon for this FMS (a capital F (F) in a shaded circle) until it is
where you would like it to be.
Click the Falcon Unit - Submit Changes link when you are done to
save your changes.
Option Description
Table 3.6 System Configuration Options