4 roughing cy cles – HEIDENHAIN MANUALplus 4110 User Manual
Page 118
118
4 Cycle Programming
4.4 Roughing Cy
cles
Cycle run
1
Calculate the proportioning of cuts (infeed), taking the parameter J
into account.
J=0: The cutting geometry is taken into account. This may result
in the use of different infeeds for the longitudinal and transverse
directions.
J>0: The same infeed is used for both the longitudinal and the
transverse direction.
2
Approach workpiece on paraxial path for first pass from X, Z.
3
Machine the workpiece according to the calculated proportioning
of cuts.
4
Return and approach for next pass.
5
Repeat 3 to 4 until the defined area has been machined.
6
Return to starting point on paraxial path.
The cycle parameter workpiece blank oversize J is
available as of NC software versions 507 807-16 and
526 488-08. With earlier software versions, the cycle
starts the machining operation from the current tool
position.