HEIDENHAIN MANUALplus 4110 - Manual (Page 483)

HEIDENHAIN MANUALplus 4110 483
9.3 ICP Example "Matr
ix"
9.3 ICP Example "Matrix"
This example illustrates how to machine a matrix using the ICP
programming feature. The individual working steps for machining the
ICP contour and integrating the contour into ICP cycles are based on
the workpiece drawing.
In the process described below, you create an ICP contour description
and a cycle program for parts production.
The machining operation is performed with the "ICP cutting
transverse" cycle.
Required tools
„ Roughing tool:
„ Position T1
„ WO = 1 Tool orientation
„ A = 93° Setting angle
„ B = 55° Nose angle
„ R = 0.8 Tool radius
„ Finishing tool:
„ Position T2
„ WO = 1 Tool orientation
„ A = 93° Setting angle
„ B = 55° Nose angle
„ R = 0.5 Tool radius
Sequence of working steps
 Clamp a workpiece blank (diameter 95 mm, length 100 mm).
 Machine setup
– Define the workpiece zero point.
– Measure the tool dimensions.
 Switch to "Teach-in" mode.
 Enter the positioning cycles for tool change.
 ICP contour programming.
 Integrate the ICP contour in the roughing and finishing cycles.