HEIDENHAIN MANUALplus 4110 - Manual (Page 144)

144 4 Cycle Programming
4.5 Recessing c
y
cles
Recess turning, radial/axial
Call the recessing menu.
Select the "Recess turning" cycle.
Select the "Recess turning, radial" cycle (see figures
at right).
Select "Recess turning, axial" (see figures on the
following page).
The cycle machines the rectangular area defined by X, Z and X2, Z2
(see also “Recess turning” on page 143).
Cycle parameters
 X, Z starting point
 X2, Z2 contour end point
 P infeed depth: Maximum infeed depth
 O recessing feed rate —default: Active feed rate
 B offset width —default: 0
 U unidirectional turning —default: 0
„ U=0: bidirectional
„ U=1: unidirectional (direction: see graphic support window)
 T tool number
 S spindle speed / cutting speed
 F feed per revolution