HEIDENHAIN MANUALplus 4110 - Manual (Page 281)

HEIDENHAIN MANUALplus 4110 281
6.2 Editing DIN Pr
ogr
a
ms
6.2 Editing DIN Programs
Call the DIN editor.
Call the program list.
Select DIN programs.
Select DIN macros.
Select a DIN program / DIN macro or define a new program number.
Call the DIN program / DIN macro.
Block functions
With the arrow keys and paging keys, you move the cursor within the
DIN program to the position you wish to delete, change or add to.
Place the cursor at the beginning of a block, NC word, or parameter.
The soft keys or menu keys enable you to select the desired function.
MANUALplus then asks you to enter additional parameters. When you
are programming cycles or traversing commands (G functions), the
function and the parameters are illustrated in the graphic support
window.
Place the cursor at the beginning of the block to select block
functions.
Loading the desired DIN program
Soft keys for block functions
Insert a new NC block with the "next"
block number below the highlighted
block.
The "Function selection" menu can be
used to add further NC commands.
The block at which the cursor is
located is deleted.
The number of the block at which the
cursor is located can now be edited.