HEIDENHAIN MANUALplus 4110 - Manual (Page 58)

58 3 Machine Mode of Operation
3.5 Set
ting up T
o
ols
Tool compensation
The tool compensation in X and Z as well as the special compensation
for recessing tools compensate for wear of the cutting edge.
Select "Set T, S, F" (only available in Manual mode).
Press Tool correct.
Select X offset for tool.
The compensation values that you determine per
handwheel are now shown in the "Distance-to-go"
display.
Transfer the compensation value to the tool table.
The T display shows the new compensation value.
The distance-to-go display is cancelled.
Repeat this procedure for the tool compensation Z and the special
compensation.
Select "Set T, S, F" (only available in Manual mode).
Select Tool correct.
Cancel the compensation value entered in X.
Repeat this procedure for the tool compensation Z and the special
compensation.
A compensation value must not exceed 99 mm.
Defining tool compensation
Deleting tool compensation values