HEIDENHAIN MANUALplus 4110 - Manual (Page 164)

164 4 Cycle Programming
4.6 Thr
ead and Under
c
ut Cy
cles
Last cut
After the cycle is finished, the MANUALplus presents the Last cut
option. You can use this function to repeat the last thread cut with an
updated tool compensation.
Sequence for the “last cut” function:
Initial situation: The thread cut cycle has been performed, and the
thread depth is not correct.
 Perform the tool compensation
 Press Last cut
 Activate Cycle Start
 Check the thread
The tool compensation and the “last cut” can be repeated
as often as necessary until the thread is correct.