HEIDENHAIN MANUALplus 4110 - Manual (Page 247)

HEIDENHAIN MANUALplus 4110 247
5.2 Editing ICP Cont
ours
Changing the ICP contour graphics
MANUALplus selects the area to be represented such
that all entered contour elements are displayed.
You can magnify/reduce the displayed graphics with
the PgUp/PgDn keys, and pan the detail with the
arrow keys. These functions are available when the
contour is displayed but is not being edited.
To isolate and display a precise detail, proceed as
follows:
When you press Zoom, a "red frame"
appears on the screen with which
you can select the detail you wish to
isolate.
"Red frame"
– To move the red frame, use the arrow keys.
– To enlarge the red frame, use the PgDn key.
– To reduce the red frame, use the PgUp key.
The adjusted "red frame" will be
displayed as a picture.
By reducing the contour, a greater
area can be displayed (if, for example,
an area of the workpiece is not
displayed in the graphics window).
All previously defined contour
elements are shown as large as
possible.
Return to the last setting of Zoom.
Calling and setting the "Zoom" function