HEIDENHAIN MANUALplus 4110 - Manual (Page 284)

284 6 DIN Programming
6.2 Editing DIN Pr
ogr
a
ms
Comments
If you enter a comment in an empty block, the block number is deleted
and only the comment is stored in this block. (An "empty block" is a
block that consists of the block number only.) If the NC block already
contains NC commands, the comment is appended to the end of the
block.
To change comments, place the cursor at the beginning of the
comment and press Change word. MANUALplus then displays the
"alphanumeric keyboard" and the current text of the comment. You
can now edit the comment as desired by changing, adding to, etc.
If you wish to delete comments, place the cursor at the beginning of
the comment and press Delete block or Delete word, as applicable.
The comment is deleted.