5 icp contour elements, turning contour, Entering lines, turning contour – HEIDENHAIN MANUALplus 4110 User Manual
Page 260
260
5 ICP Programming
5.5 ICP Cont
our Elements, T
u
rn
ing Cont
our
5.5
ICP Contour Elements, Turning
Contour
Entering lines, turning contour
Use the menu symbol to select the direction of the contour element
and assign it a dimension.
When defining horizontal and vertical linear elements, it is not
necessary to enter the X and Z coordinates, respectively.
MANUALplus inhibits the corresponding input field if no unsolved
elements exist.
Select the line direction.
You enter the dimensions of the line and then define the transition to
the next contour element.
Parameters for vertical line
XS, ZS starting point in X/Z
(= end point of last element)
X target point in X
Xi target point in X
(incremental): Distance from starting point to
target point
L length of line
F special feed
Parameters for horizontal line
XS, ZS starting point in X/Z
(= end point of last element)
Z target point in Z
Zi target point in Z
(incremental): Distance from starting point to
target point
L length of line
F special feed
Vertical/horizontal lines