HEIDENHAIN MANUALplus 4110 - Manual (Page 154)

154 4 Cycle Programming
4.5 Recessing c
y
cles
ICP recess turning radial/axial, finishing
Call the recessing menu.
Select the "Recess turning" cycle.
Select "ICP recess turning radial " (see figures at upper
and center right).
Select "ICP recess turning axial" (see figures on the
following page).
Press the Finishing run soft key.
The cycle finishes the contour area defined by the ICP contour (see
also “Recess turning” on page 143). At the end of cycle, the tool
returns to the starting point.
Cycle parameters
 X, Z starting point
 RB depth compensation
 I, K workpiece-blank oversize X, Z
 N ICP contour number
 T tool number
 S spindle speed / cutting speed
 F feed per revolution
With "oversizes I, K" for the workpiece blank, you define
the material to be machined during the finishing cycle. It is
therefore absolutely necessary to define the oversizes for
recess turning—finishing.