HEIDENHAIN MANUALplus 4110 - Manual (Page 264)

264 5 ICP Programming
5.5 ICP Cont
our Elements, T
u
rn
ing Cont
our
Chamfer/rounding, turning contour
Select form elements or chamfer/rounding.
Choose chamfer.
Choose rounding.
The corner is predefined by the starting point. You need only enter the
"chamfer width B" or "rounding radius B."
Parameters
 B chamfer width —or
 B rounding radius
 J element position: "imaginary approaching reference element"
„ J=1: Transverse element in the positive X-axis direction
„ J=–1: Transverse element in the negative X-axis direction
„ J=2: Longitudinal element in the positive Z-axis direction
„ J=–2: Longitudinal element in the negative Z-axis direction
 F special feed
Chamfer