Blank-bar/tube, Blank—bar/tube, 2 w o rk piece blank cy cles – HEIDENHAIN MANUALplus 4110 User Manual

Page 86

Advertising
background image

86

4 Cycle Programming

4.2 W

o

rk

piece Blank Cy

cles

Blank—bar/tube

Select the function for defining a workpiece blank.

Select "Blank—bar/tube."

The cycle describes the workpiece blank and the setup used. This
information is evaluated during the simulation.

Cycle parameters

X outside diameter

Z length

—including transverse allowance and clamping range

I inside diameter

for workpiece blank "tube"

K right edge

(transverse allowance)

B clamping range

J type of clamping

„

0: Not clamped

„

1: Externally clamped

„

2: Internally clamped

Advertising
See also other documents in the category HEIDENHAIN Equipment: