HEIDENHAIN MANUALplus 4110 - Manual (Page 119)

HEIDENHAIN MANUALplus 4110 119
4.4 Roughing Cy
cles
ICP contour-parallel finishing, longitudinal/
transverse
Call the "Roughing, longitudinal/transverse" cycles.
Select "ICP contour-parallel, longitudinal" (see figures
at right).
Select "ICP contour-parallel, transverse" (see figures
on the following page).
Press the Finishing run soft key.
The cycle finishes the contour area defined by the ICP contour. When
the cycle is completed, the tool remains at the cycle end position.
Cycle parameters
 X, Z starting point
 N ICP contour number
 T tool number
 S spindle speed / cutting speed
 F feed per revolution
Danger of collision!
If the tool angle and the tool point angle have not been
defined, the tool plunge-cuts at the plunging angle. If the
tool and point angles have been defined, the tool plunge-
cuts at the maximum possible plunging angle. In this case,
the resulting contour will not be completely finished and
may need to be reworked.