HEIDENHAIN MANUALplus 4110 - Manual (Page 423)

HEIDENHAIN MANUALplus 4110 423
7.
4 T
ool D
a
ta
Drilling tools
Select drilling tools.
Tool parameters
 X setup dimension in X
 Z setup dimension in Z
 I hole diameter
 WO tool orientation: For code number, see graphic support
window
 B point angle —Range: 0° < B <= 180°
 DX wear compensation in X: Range: –100mm < DX < 100mm
 DZ wear compensation in Z: Range: –100mm < DZ < 100mm
 Q tool text: Reference to tool text
 H tool driven —default: 0
„ 0: Not driven
„ 1: Driven
 MD direction of rotation —default: Not defined
„ 3: M3
„ 4: M4
 TS cutting/spindle speed: default: Not defined
 TF feed rate —default: Not defined
 PT tool life —default: Not defined
 RT: Display field for remaining tool life
 PZ quantity —default: Not defined
 RZ: Display field for remaining quantity
„ For drilling operations with "constant cutting speed,"
"drilling diameter I" is used to calculate the spindle
speed.
„ The parameters I and B are used to depict the cutting
edge during simulation.
„ Using the parameter "driven tool H," MANUALplus
determines whether a driven tool is being used.