HEIDENHAIN MANUALplus 4110 - Manual (Page 217)

HEIDENHAIN MANUALplus 4110 217
4.8 Milling Cy
cles
Cycle parameters (first input window)
 X, Z starting point
 C spindle angle (C-axis position)—default: Current spindle angle
 C1 angle of figure center —default: Spindle angle C
 X1 milling top edge —default: Starting point X
 Z1 figure center
 X2 milling floor
 L rectangle length
„ Rectangle: Length of rectangle
„ Square, polygon: Edge length
„ Circle: No input
 B rectangle width
„ Rectangle: Width of rectangle
„ Square: L=B
„ Polygon, circle: No input
 RE rounding radius —default: 0
„ Rectangle, square, polygon: Rounding radius
„ Circle: Radius of circle
 A angle to Z axis —default: 0
„ Rectangle, square, polygon: Position of figure
„ Circle: No input
 Q number of edges —default: 0
„ Q=0: Circle
„ Q=4: Rectangle, square
„ Q=3: Triangle
„ Q>4: Polygon
 T tool number
 S spindle speed / cutting speed
 F feed per revolution