HEIDENHAIN MANUALplus 4110 - Manual (Page 7)

HEIDENHAIN MANUALplus 4110 7
3.1 Machine Mode of Operation ..... 42
3.2 Switch-On / Switch-Off ..... 43
Switch-on ..... 43
Traversing the reference marks ..... 43
Monitoring EnDat encoders ..... 44
Switch-off ..... 45
3.3 Machine Data ..... 46
Input and display of machine data ..... 46
Tool call ..... 47
Tools in different quadrants ..... 48
Feed rate ..... 48
Spindle ..... 49
3.4 Machine Setup ..... 50
Defining the workpiece zero point ..... 50
Setting the protection zone ..... 51
Defining the tool change position ..... 52
Setting C-axis values ..... 53
3.5 Setting up Tools ..... 54
Tool compensation ..... 58
Tool life monitoring ..... 59
3.6 Manual Mode ..... 60
Tool change ..... 60
Spindle ..... 60
Handwheel operation ..... 60
Jog operation (joystick) ..... 60
Cycles in Manual mode ..... 61
3.7 Teach-In Mode ..... 62
3.8 Program Run Mode ..... 63
Faulty programs ..... 63
Before executing a program ..... 63
Start block search and program execution ..... 64
Entering compensation values during program execution ..... 65
Setting compensation values with the handwheel ..... 66
Program execution in “dry run” mode ..... 67
3 Machine Mode of Operation 41