HEIDENHAIN MANUALplus 4110 - Manual (Page 274)

274 5 ICP Programming
5.7 ICP Cont
our Elements on the Lat
e
ra
l Surf
ace
Entering circular arcs on the lateral surface
Arc with center and radius
Arc with radius
Arc with center
You enter the dimensions of the arc and then define the transition to
the next contour element.
Parameters (for "Arc with radius," the center is not requested. For "Arc
with center point," the radius is not requested.)
 ZS, YS starting point (YS as linear dimension—reference:
diameter XS)
 CS starting point as angular dimension
 XS unrolled diameter
 Z target point
 CY target point as linear dimension (reference: diameter XS)
 C target point as angular dimension
 K, CJ center point (CJ as linear dimension—reference: diameter
XS)
 CM center point as angular dimension
 R radius
 F special feed
Entering an arc