HEIDENHAIN MANUALplus 4110 - Manual (Page 433)

HEIDENHAIN MANUALplus 4110 433
8.2 P
a
ra
met
e
rs
Speeds [2] For spindle 1 (main spindle) and spindle 2 (driven tool):
„ Zero point shift (M19) [°]
The parameter determines the offset in position between the
spindle reference point and the reference point of the angle
encoder (rotary encoder). After receiving the reference pulse
from the rotary encoder, the current actual position is overwritten
by the parameter value.
„ Number of revolutions for chip breaking
Number of additional spindle revolutions for disengaging the tool
during spindle stop.
„ M5/M19 Angle (usually set with "Set T, S, F").
„ Speed value VConstant (G96) (usually set with "Set T, S, F").
„ Speed value NConstant (G97) (usually set with "Set T, S, F").
„ Speed limit (G26) (usually set with "Set T, S, F").
"NC switches [3]" menu item
Display type [1] The data is displayed in the "Actual value display" fields (machine
window).
„ Actual display type—the numbers have the following meaning:
„ 0: Actual value
„ 1: Following error
„ 2: Distance of traverse
„ 3: Tool tip—referenced to machine zero point
„ 4: Slide position
„ 5: Distance between reference cams / reference pulse
„ 6: Nominal position
„ 7: Difference between tool tip / slide position
„ 8: Nominal IPO position
Tool measurement type [2] This parameter defines how to determine the tool set-up
dimensions in setup mode.
„ Type (of tool measurement):
„ 0: Touch-off
„ 1: Touch probe
„ 2: Optical gauge
„ Measuring feed: Feed rate for approaching the touch probe
„ Measuring range:
„ Measuring range: The tool stops when it has traversed to the
maximum measuring range without reaching the touch probe.
Current parameters