HEIDENHAIN MANUALplus 4110 - Manual (Page 543)

HEIDENHAIN MANUALplus 4110 543
Ov
erview of G functions
Overview of G functions
Definition of workpiece blank Page
G20 Standard blank (bar, tube) 288
G21 Contour of workpiece blank 289
Tool positioning without machining Page
G0 Positioning in rapid traverse 290
G14 Approach the tool change position 291
Simple linear and circular movements Page
G1 Linear path 292
G2 Circular arc with incr. center dimensioning 293
G3 Circular arc with incr. center dimensioning 293
G12 Circular arc with abs. center dimensioning 295
G13 Circular arc with abs. center dimensioning 295
Feed rate and spindle speed Page
G26 Speed limitation for spindle 297
G126 Speed limitation, driven tool 297
G64 Interrupted (intermittent) feed 297
G193 Feed per tooth 298
G94 Constant feed 298
G95 Feed per revolution 298
G195 Feed per revolution for driven tool 298
G96 Constant cutting speed 299
G196 Constant cutting speed for driven tool 299
G97 Spindle speed (in rev/min) 299
G197 Spindle speed (in rev/min) for driven tool 299
Tool-tip/cutter radius compensation (TRC/MCRC) Page
G40 Deactivate TRC 301
G41 Activate TRC 301
G42 Activate TRC 301
Tool compensation Page
G148 Changing the cutter compensation 302
G149 Additive compensation 303
G150 Compensate right tool tip 304
G151 Compensate left tool tip 304
Zero point shifts Page
G51 Zero point shift 305
G56 Additive zero point shift 306
G59 Absolute zero point shift 307
Oversizes Page
G57 Paraxial oversize 308
G58 Contour-parallel oversize 309
Roughing cycles Page
G80 End of cycle 310
G81 Longitudinal roughing 319
G817 Longitudinal contour roughing 311
G818 Longitudinal contour roughing 311
G819 Longitudinal contour roughing with
recessing 313
G82 Transverse roughing 320
G827 Transverse contour roughing 314
G828 Transverse contour roughing 314
G829 Transverse contour roughing with recessing 316
G83 Simple contour repeat cycle 321
G836 Contour-parallel roughing 317
G87 Line with radius 322
G88 Line with chamfer 323
G89 Contour finishing cycle 318