HEIDENHAIN MANUALplus 4110 - Manual (Page 367)

HEIDENHAIN MANUALplus 4110 367
6.20 F
a
ce Mac
h
ining
 O roughing/finishing (default: 0)
„ O=0: Roughing
„ O=1: Finishing
 J milling direction: For polygons without chamfers/roundings, J
defines whether a unidirectional or bidirectional milling operation is
to be executed.
„ J=0: Unidirectional
„ J=1: Bidirectional
Notes:
„ With "Q=0," one of the following figures is programmed in the
subsequent command. A G80 is programmed after the command.
„ G304—circle
„ G305—rectangle
„ G307—polygon
„ A polygon that has been defined with G797 (Q>0) is in the center. A
figure defined in the subsequent command can be outside the
center.
„ The cycle calculates the milling depth from "Z" and "ZE," taking the
oversizes into account.