HEIDENHAIN MANUALplus 4110 - Manual (Page 493)

HEIDENHAIN MANUALplus 4110 493
9.3 ICP Example "Matr
ix"
ICP finishing
The ICP contour "777" ("Matrix") is also used for the
finishing cycle.
Checking the ICP finishing cycle
With the graphic simulation function, you can check
the execution of the ICP finishing cycle (Graphics soft
key). You can then transfer the cycle to the cycle
program with the Save or Overwrite.
MANUALplus finishes the contour in the defined
"contour direction" (see figure to the bottom right).